How to unbrick Motorola Moto G (3rd gen)

How to unbrick Motorola Moto G (3rd gen)

 

 Download the firmware



XT1540 [Android 5.1.1]
XT1541 [Android 5.1.1]
XT1542 [Android 5.1.1]
XT1543 (Dual-SIM) [Android 5.1.1]
XT1544 (Dual-SIM with HDTV) [Android 5.1.1]
XT1548 (CDMA)
XT1550 (Dual-SIM) [Android 5.1.1]

Download the Moto G (3rd generation) PC drivers from here. Install these drivers to your PC, it is very necessary so your device can be detected on PC.


Download the minimal Adb fastboot Tool (tool to flash this stock firmware) from here. Extract it to your PC and remember the location.


Note:- After you download the firmware zip file, make sure to extract stock firmware in the ADB fastboot folder.

 

 How to unbrick Motorola Moto G (3rd gen)

 

  1. Turn off the device and wait 3-5 seconds.
  2. Now, press and hold Volume down and power buttons simultaneously to get it started in Fastboot mode. You’ll see the following screen,fastboot mode moto g
  3. On PC, run the “Run Me.bat” file from extracted Adb fastboot Tool. The command prompt will appear.
  4. Now connect your handset to your PC using USB cable.
  5. Now Type the following commands one by one on it, and press enter


    mfastboot flash partition gpt.bin

    mfastboot flash motoboot motoboot.img

    mfastboot flash logo logo.bin

    mfastboot flash boot boot.img

    mfastboot flash recovery recovery.img

    mfastboot flash system system.img_sparsechunk1

    mfastboot flash system system.img_sparsechunk2

    mfastboot flash system system.img_sparsechunk3

    mfastboot flash modem NON-HLOS.bin

    mfastboot erase modemst1

    mfastboot erase modemst2

    mfastboot flash fsg fsg.mbn

    mfastboot erase cache

    mfastboot erase userdata

    mfastboot reboot


    Disconnect your phone from PC .  All done! You’ve successfully repaired your bricked Motorola Moto G (3rd gen).

 

No comments

Powered by Blogger.